CHEMICAL NATURE:
Naphtha oil with corrosion inhibitors and agents of extreme (organic)pressure.
When it is mixed with water, white-milky emulsions of high stability are obtained.
 
 

TECHNICAL AND PHYSICAL DATA:
    Aspect: Liquid
    Smell: Characteristic
    pH(value): 9.5 +/- 1 to 20o C
    Flash point: 165 min. (V/A), (ASTM D-92)
    Colour: Dark-brown
    Density: 0.91 g/c.c. to 20o C +/-0.05
    Solubility: Totally soluble in water

TESTED AND ASSENTED BY: 
    Ministry of Health no: 1940/28.10.1998

CHARACTERISTICS:
  It combines excellent lubrication (reducing the friction between the
         metal and the tool, so that the durability of the tool can be prolonged)
         with the best cooling (eliminating the heat produced by the removing of
         the splinter) that produces an adequate temperature on the contact surface;
  It contains neither Nitrate, Silicon nor other dangerous products that cause
        harm to those who use it;
  It neither produces smoke or toxic vapours;
  It contains additives well selected that provide high quality finishing,
        therefore prolonging the durability of the tools, reducing the expenses of
        production for the same number of parts, by the means of reducing the
        friction between part-tool-splinter and allowing higher cutting speed;
  It contains bacteriological additives that action against the micro-organisms;
  It confers a good protection against corrosion and it is very economical.

APPLICATIONS:
    - It is indicated for iron, steel, high allied and stainless steel cutting, aluminium
        and its alloys, favouring in this case the rapid evacuation of the splinters and
        avoiding the premature wear of the edge of the tool;
    - It is indispensable in processes such as: lathing, cutting off, milling, etc. of
        every type of metals;
    - In steel-works, at the peeling of the metal bars, at Kieserling machines,
        Bordiere machines, etc.
    - In concentration of 1-2% it can be used to high precision steel grinding, when
        it is necessary the adding to this fluid of a lubricant element which is
        supposed to reduce the wear of the tool during the process.

USE:
    -Dilution between 2 to 20 % according to the hardness of the operation which is to be done;
    -5 % for: lathes, gear machines, thread machines, boring machines, boring and milling machines;
    -Pure or diluted 50 % for threading with screw taps and rethreading dies;
    -These dilution are only for guiding, but they can be modified according to experience;
    -Before using IBERSOL - 2000 and also in order to preserve all its properties, it is recommended
     the previous cleaning of the cooling circuits with the product LM - 10 (1 part with 4 parts
     of water) followed by rinsing with clean water.

WARNINGS:
  -Do not effect uncontrolled throwing;
  -Do not swallow.